creating a left and right margin in word

My print only show the bottom side of the red box. If the the side of the red box is too far from the edge of the paper, you will need to decrease the margin of the edge. If you do not see a side of the red box, you will need increase the margin of that edge. Look for a bounding red box on the print which will defines the margin area. Print out another test print with the margin settings Since the top edge is fine, leave it at zeroĥ.The bottom edge is above the 10 mark (maybe 13)Ĥ.The right edge is to the right of the 10 mark (maybe 5).The left edge is to the left of the 10 mark (maybe 5).Looking at the test print and using the margin ruler. Look at the test print and check if the bounded area falls within the print area It depends on the orientation of the print, portrait vs. Determine where the top, left, right and bottom are on the test print. Note: Make sure 'automatically rotate' is disabled for this test.

Making sure to select a borderless paper size.įor version 6 or older, go to Settings > Printing and setup your printer, and then press the Test button.įor version 7 or newer, go to Settings > Printer Setup to setup your printer, and then press the Test button These paper sizes include the bleed margins for the printer, so the center of the paper will be the center of the print out. Instead of adjusting the margins, you can create a new photo layout in the layout editor, and select one of the paper sizes for your printer. Note: If you are using a DNP, Mitsubishi, Hiti, Sony, Shinko, or Fuji printer, leave all the margins set to 0. If you have 'Automatically scale photo to fit paper' and/or 'Center layout on paper' enabled, you can adjust print boundary that the layout is scaled and centered within. You can adjust the position of prints by adjusting the margins.

Creating a left and right margin in word